The aquadrive X4
can accommodate up to 4 (!) Hard drives in it, which are completely
encapsulated in the well-cooled housing.
This is the new premium hard drive
cooling series, constructed with Delrin, which absorbs vibrations better
than aluminum because of its structure.
Inside, large copper plates are
installed, that weight approximately as much as the aquadrive aluminum.
These are in turn surrounded by a water
jacket, which also absorbs vibrations and insulates.
Accommodate both SATA and PATA drives.
The integrated reservoir is filled
through an included spray bottle from the front.
By two tubes, the two containers in the
side profiles of aquadrive X4 are connected with each other, which
compensates for the level. The
current status can be easily read the display in the right profile of a
small red ball.
Suitable for hard drives up to 15,000
The aquadrive X4 is supplied
including 4 rubber bearings and 4 Phillips screws for mounting in three
5 1 / 4 bays. Additional mounting
threads allow mounting even on the upper Befestungspunkten.
The use of the supplied rubber buffer is
only possible when mounted on the lower mounting points.
The mounting means of rail systems is
Designed for up to four 3.5 "hard drives
in three 5.25 inch bays
Material: Delrin / copper / stainless
Reservoir capacity: 250 ml
Dimensions: three 5.25-inch drive bays,
Depth: 171.5 mm
Weight (empty, without hard drives): 2.65
Connector thread: G1 / 4 "
aquadrive X4 Hard Drive Cooler
four rubber bearings with mounting screws