Features

• ATX PSU each output connectors check
• Tests 20-pin and 24-pin power supplies
• Tests SATA power
• Tests Pentium 4 power connector
• Tests PCI-Express power connectors
• Tests Xeon power connectors
• Tests Floppy drive connectors
• Tests standard 4-pin power supply connectors
• Accurate voltage indicator +/-V(+12V1/+5V/+3.3V/5VSB/+12V2/-12V)
• ATX P.G value display.
• Lower or higher P.G values alarm
• Lower voltage detected alarm.
• Over voltage alarm.
• No voltage detected alarm.
• Dimension : H * L *D : 64mm * 150mm * 18mm

Instructions:

1. Plug-in 24pin and plug-in (P4 / P6 or P8) connector into the tester before turn on power.r> - - 20pin ATX PSU: use P4 connector.
- 24pin ATX PSU: use P6 connector.
- EPS PSU: use P8 connector.
2. Turn on your power supply
3. LCD shows each voltage and P.G. value on the screen automatically and you will hear 2 beeps.
4. ATX power output connector checks one by one.
- If power output is working, the LED will light on
- If power output failed, the LED will not light on.
5. Plug-in (HDD/Floppy) connector and check LED light. (+12V1/+5V).
6. Plug-in SATA connector and check LED light (+12V1/+5V/+3.3V).
7. Remove the connector after your checking.
8. DO NOT plug-in 2 connectors in to the tester at the same time. ( Only 24pin and (P4/P6/P8)
9. Abnormal voltage detected will not display on the screen.
10. No voltage detect, "LL" will display on the screen.
11. Detected Voltage lower than Min. value, "LL" will display on the screen.
12. Detected voltage higher than Max. value, "HH" will display on the screen.
13. When detected voltage is lower than table value (A), will alarm.
14. When detected voltage is higher than table value (B), will alarm.
15. P.G. value detected lower 100ms or higher 900ms, P>G value is abnormal and alarm will sound.

When an abnormal value is detected, the unit will alarm and an appropriate digit will blink on the screen.

Each voltage normal range:
Reference field Low (A) and High (B)
+/-5%: +5V, +5VSB, +3.3V
+/-10%: +12V1, +12V2, -12V

Note:
The -5V DC output is took off from Intel ATX12V design guide since the 1.2 version.
1. The -5V usage was for last generation ISA slot. But the old ISA had been phased out since 1993~1994.
2. Neither P3 nor P4 systems will need -5V output.

Important Note:
This product is designed only for power supply output tests. Do not leave it connected to the power supply unattended. It r> generates heat and could possibly damage your power supply.

Availability: Usually ships the same business day

PST-3$20.50 Qty: